In recent years, more and more attention has been paid to environmental protection issues, and the country has also begun to carry out strict investigation. All aspects of the production of the stone mill will be based on environmental protection. For example, before crushing, the stone will be watered to increase the humidity, so as to prevent a lot of dust from being generated during crushing. But after increasing the humidity of the stone, the problem also arises. What kind of crusher is better for handling wet materials? How much is one? This article will give you a detailed introduction.

一、 What crusher is better for handling wet materials? It mainly uses the following

(1)Compound crusher

The composite crusher has a large crushing ratio and a high crushing moisture content. It is most ideal for processing materials with high moisture content. The discharge particle size can be adjusted at will without screen bar. The materials with large water content and sediment content will not be blocked. The non crushing materials can be automatically discharged into the machine body without causing damage to the equipment.

Equipment performance:

1. The working noise of the equipment is low, lower than 75db, and the production workshop is free of dust, which fully meets the environmental protection requirements;

2. The equipment is made of wear-resistant materials, with less wear and tear, convenient maintenance, long service life, long sustainable production time and low production cost;

3. The equipment has reasonable design, strong stability, high production efficiency and can achieve low energy and high yield.

(2) Impact crusher

There is no grate at the bottom of the impact crusher, and the crushed materials are discharged directly from below the crushing chamber, which is not easy to block. In addition, the plate feeder with wear-resistant liner can be selected at the discharge port to accelerate the discharging speed of stone, so it is suitable for handling high wet stone.

Equipment characteristics:

1. When the water content of the materials handled by the impact crusher is too large, the feed chute and the impact plate of the impact crusher can be equipped with heating devices to prevent the materials from sticking;

2. The output particle size can be adjusted, the product shape is cubic, and the stone powder is less;

3. Compared with the hammer crusher, the rotor of the impact crusher has greater momentum, which is suitable for crushing harder materials and has lower energy consumption;

4. The wearing parts of the equipment are not easy to be worn, the metal utilization rate is high, the service life is long, and the replacement and maintenance are simple.

(3) Double stage non screen bottom crusher

This model can solve the problem of high moisture content of materials in open-air production. The machine is designed without screen, which will not lead to machine blockage. Because there is no screen bottom and screen in the design of the two-stage crusher, even if the moisture point of materials is large, there will be no blockage, and normal production can be carried out in rainy days.

Equipment performance:

1. There is no screen grate at the outlet, the mixture has good passing performance, and the wet material is not sticky or blocked;

2. Hammer head, lining plate and rotor are made of various alloy high wear-resistant materials with long service life; Hydraulic hoist casing, replacement and maintenance save time and effort;

3. High degree of automation, easy to open and close in use, light and fast, and reliable operation;

4. Double rotors with upper and lower structure, double smashing with upward impact, hammering and smashing in the cavity, large crushing ratio, high output, low energy consumption, power saving of more than 20%, uniform grain size and good quality;

5. When it is generated, the dust pollution is less, the noise is low, and the effect of environmental protection is achieved.

In fact, many crushers are suitable for wet material crushing. You can choose a suitable crusher according to the actual situation (stone characteristics). If you encounter stones with high humidity, we can also adopt the production process of drying before crushing.

二、 How much is a crusher for handling wet materials?

How much is a crusher for handling wet materials? As far as the current mining machine market is concerned, the quotation of crusher is related to the model manufacturer, and the quotation of equipment produced by different manufacturers is different. The demand and output value of different customers for processing finished sand and gravel products are different, so the selection of corresponding crusher equipment models is also different.